All Zephyrtronics Equipment is Engineered and
Manufactured in the United States of America.
"Vision Award" Presented to Zephyrtronics at the Surface
Mount Int'l Expo in Silicon Valley Recognizing Its
Breakthrough Approach For PCB's at the Bench!
way to remove and repair sensitive devices" --
The Editorial Staff of
AirBath is Featured
in Ray Prasad's Definitive Text "Surface Mount
We First Introduced to the World Low Temperature Rework & DeSoldering SMD Chips Quick & Easy
Video Demonstrations & PresentationsThe Best Solution for SMD, SMT, BGA Rework and Repair and PCB Preheating
How to Solder & De-Solder & Preheat BGA's, SMD's, QFN's & More.
Video: SMD Removal at Below 150°C in
Less Than 180 Seconds! This short video
demonstrates how to de-solder and remove SMD devices
in less than 3 minutes through the synergistic
DeSolder Wire and the
AirBath Preheating Systems.
Now any technician can confidently remove any SMT
component (QFP's, PLCC's, SOIC's SOL's SOJ's SMD
Sockets) without any expensive and individualized,
specialty nozzles & at only 150°C!
Learn how you can remove any chip quickly without ever
burning a board, lifting a pad or damaging your
component. Just more of the exciting Science of
Zephyrtronics™ that is now utilized daily by NASA and
the Department of Defense. After the video, visit our
Systems Guide & Directory
for greater details and specifications.
Video Duration: 5 minutes.
Video: The Science of Low Temperature Soldering &
This video teaches how to place, remove, rework
and repair innumerable SMD's and Thru-Hole Devices
including ceramic capacitors, glass diodes, flex
circuits and resistors without damage to the substrate,
its pads, traces or the chips...when the "science" is on
Using animation and charts, the video
teaches the three critical thermal zones that encompass
most PCB's during production and how these same 3 zones
apply to PCB's at a bench in prototyping, rework and
After the video, visit our
Systems Guidefor more details. Duration: 9 minutes.
The 4 PCB Preheat Methods.This
comparative video juxtaposes the 4 current methods of
preheating PCB's spotlighting their drawbacks and
advantages. The viewer sees use of hot plates, infrared
(IR) preheating, industrial ovens and the popular
bottom-side forced convection (AirBaths™)
along with comparative charts and graphs.
The video clearly demonstrates why
bottom-side, forced convection method became the first
choice of electronic manufacturers around the globe, why
it is more effective and better suited to PCB
prototyping, rework and low volume production runs when
soldering & desoldering SMD, BGA, QFN & Thru-Hole chips.
Duration: 9 minutes.
Witness the eyebrow-raising and
uncanny multiple functions and utilities that made the
ABC Series the most popular PCB holders on the planet
for nearly 20 years. There's a lot more than just meets
the eye with these transforming ABC Adjustable Board
Cradles. Duration: 4 minutes.
Video shows board prep, fluxing, chip
alignment, soldering, desoldering & PCB clean-up after
chip removal. The video shows quality PCB inspection
after desoldering a BGA as it actually lifts off the
PCB...hands-free! Photo and observations from NASA are
included in the video. Afterward visit our
for more details. 10 minutes.
Importance of ramping, preparing the
PCB, applying solder paste, hot air
reflow of the SMD, clean-up &
inspection. See how easy using solder
paste instead of solder wire is. All
equipment, tools and supplies shown in
video are included in any of our popular
Video: 5 minutes.